

V-rings
PTFE V-rings are used mainly for sealing on plunger and piston rods of hydraulic cylinders, presses, valve spindles and controls. Several sealing lips and the long contact surfaces ensure a good sealing performance.
The seal sets consist of a pressure ring, a back-up ring and V-rings, which in number and design are adapted to the various operational conditions. This makes them more insensitive to contamination from the operating medium than one-piece seals. Further decisive advantages are their form stability, which make V-rings insensitive to pressure peaks, and their preload adjustability (spacer plates, springs). In addition, they have a favorable breakaway torque even after a long standstill period.
Standard profiles are manufactured from pure PTFE or PTFE with fillers. There is an elastic design for the low pressure range, a design is available for a broad product spectrum, where the sealing function is given due to a wedge effect and a pressure resistant, relatively rigid design for harsh operating conditions. V-seal sets are made by machining and can be produced in a variety of diameters and heights.
Medium pressure V-seal set (MDM)
– Pressure range: < 50 bar
– Elastic profile version
High pressure V-seal set (HDM)
– Pressure range: 50 to 100 bar
– Profile relatively rigid, seals through a wedge effect
Extreme pressure V-seal set (HöDM)
– Pressure range100 bar – 250 bar
– Preferable for static sealing functions and pulsating pressures

Materials
PTFE pure | low friction coefficient, low gas permeability, low thermal conductivity, limited abrasion resistance, application in food environments |
PTFE + glass fiber | high pressure resistance, improved wear resistance, not alkaline-resistant, application especially in food environments |
PTFE + carbon | good pressure resistance, improved thermal conductivity, good wear resistance, particularly suited for water as medium, filler can be attacked by oxidizing media |
PTFE + graphite | good gliding and lubricating properties, conserves counter-running surfaces, is particularly suited for soft counter-running surfaces, very good in steam operations, not suitable for hard metals, filler can be attacked by oxidizing media |
PTFE + bronze | high pressure resistance, good thermal conductivity, good running behavior, filler can be attacked by acids |
Surface finish
Running surface hardness
Application limits
Pressure: up to 300 bar
Stroke speed: Continuous operation: 0.5 m/s, intermittent operation 1.2 m/s
Temperature: -200°C to +240°C
Roughness depth | Ra |
Dynamic sealing surfaces | ≤ 0,2 µm |
Static sealing surfaces | ≤ 1,6 µm |
Lead-in chamfers, groove flanks | ≤ 3,2 µm |
PTFE pure (CCN-01) | ≥ 30 HRC |
PTFE compounds | ≥ 50 HRC |
Product data sheet (PDF)
Our data sheet for V-seals can be found here.
Overview of materials for dynamic seals (PDF)
The following overview is a selection of typical PTFE materials used for seals, guide elements and wipers. Further PTFE materials are available for special applications.
Get your product quickly!
To help you quickly and easily find the best solution for your products, please send us your product inquiry via the form below. So you can send us your specifications and requirements directly.
Product request V-rings
Discover our product competence.
With our products navigator you can get to the product you are looking for quickly.